DoctorAuto
10-28-2002, 06:58 AM
I was tired of my crusher slipping and I do not need reverse so this is what i did.Pulled the trany apart removed y2 from the main shaft, Then went to the hard ware store bought some red sheet packing for washers and gasket [rubber] size 1/16 size cut a strip the length of the clutch housing[ML6] inserted it all around the bell.Remove ML5 clutch shims.Re in stall the clutch shoes,this will be a little tight just cut some ofthe edges off ML7[clutch cam]to fit.Re install with out Y2.There you have it direct drive.I have a .21 Hyper so it really flies now.The cost 4.99 for the gasket.I tested this the hard way from doing full throttle jumps four tanks and no problems yet.And yes it does do wheelies when it lands and rides them well.[No not from a standing start yet]