ESC Help

[animalstl]

I Need an ecs for a rustler that is fairly inexpensive and can handle a 14 turn motor. Any Ideas?

[FSU427P]

Duratrax streak. Handles down to 12 turns if I'm not mistaken and I think you can pick one up new for about $40 anywhere.

[TRF Drive Hard]

Here are the specs;)
http://www2.gpmd.com/image/d/dtxm1030.jpg

This is the DURATRAX "One-Button Set-Up" Speed Control, for Stock or Modified
Motors Down to 12 Turns, on 4-10 Cells. This is the FUTABA "J" connector
version. FORWARD ONLY! Has BEC circuitry.

FEATURES: Current limiter circuitry lets the modeler adjust the current to the
motor to help prevent wheel spin during heavy acceleration.
"One button set-Up" allows for a quick and easy speed control set up.
Digital glitch-prevention
Reverse voltage protection
Ultra high frequency gives smoother throttle response, cooler running
motors, and greater motor life.
ABS braking helps prevent wheel lockup during hard braking, allowing
harder and straighter stops.
Built in on/off switch lets the vehicle be turned at the flip of a
switch, not as soon as the battery is plugged in.

INCLUDES: Two black anodized heatsinks (one small, one large)
One Steak Speed Control Unit
Motor capacitor kit (Only Two Capacitors Used For Speed Control, One
Will Be A Spare)
Double-sided mounting tape (1" x 1")
One Schottky diode (silver line goes to positive)
Pre-installed standard type battery connectors
Pre-installed bullet style motor connectors
Pre-installed reciver connector,(FUTABA -- DTXM1031 is for Air)
Mounting and hook up instructions

SPECS: Voltage input: 4 to 10 cells (4.8-12V) On-resistance: .004 Ohms
Operating frequency:3500 Hz
Maximum current: 300 Amps Weight: 2.1 oz.
Case size: 1.64"L x 1.5"W x .66"H RX wire length: 10.5"
Batt wire length: 4.5"

COMMENTS: This is the FUTABA "J" version, also works with, JR, or HRC.
For the AIRTRONICS vesion, use DTXM1031

[animalstl]

Im Kinda New To All This Anything Else i Should Know?