hammer help

[Baja-Destroyer]

my hammers servos arnt responding they were last nigth after i used it but they got wet i think they need to dry out more but i want to kow for sure the steering servo hasnt worked since last night but the throttle servo has on and off plz help me

BiN

[laxmasta2039]

unscrew the bottoms of both servos AND the reciever, then wait a bit, and spray WD-40 in them. this happened at my race yesterday WHILE i was flipping on my radio right before a heat [before the 2-minute hot pit came on] and i was still able to launch and win that heat. you might want to put a peice of tape on the seam between the servo top and main peice when you're doing this, otherwise the gears could fall out of line in the servos [the whole thing is held together by those 4 screws, so when you unscrew the bottom you're also unscrewing the top].

Joe

[Baja-Destroyer]

i think it just needs more time to dry out if it dont in a couple day im calling hobbico for my warranty

[laxmasta2039]

they'll just tell ya you shouldn't have gotten it wet. you MUST spray them out if you want them to work.

Joe

[lovinnitro]

Listen to Joe, Joe is wise:cool:

[laxmasta2039]

actually,
Joe has just had the exact same problem yesterday, and several VERY wise racers told him what to do. worked like a charm too, so im just passin' on the info to anyone whos smart enough to take advice. lol

Joe

[Doubledog]

I'll apply that next time I run . Thanks.

[Baja-Destroyer]

well the throttle is working perfect now still no steering if there not working by tomorrow im going to spray them