Cooling Fan for 959 How do i do it?

[ctimm]

I need to know how to install an aux cooling fan on my MRC 959 charger, what kind of fan, and how do wire it up???
Any advice would be appreciated!!!;)

[blownsi]

www.theshreves.com/rc_stuff/brain_surgery.htm

Follow the instuctions above. You will need a cheapo screwdriver from the dollar store to dremel. Also I used 2 50 watt resistors cause my radio shack was out of 100's but it works the same, you can use a volt meter to check for correct voltage. Just make good clean solders, route everything neatly and take your time. It's honestly very easy and takes less than an hour. One thing though you will make quite a mess from dremelling all the plastic, it tends to spray everywhere.

[krisI.925]

i did this to my charger to. Its works great but make sure you buy a medium sized fan. I went over kill and bolted a large one on the back and when it charges it really slows that fan down.

[ctimm]

Thank you gentlmen for your great advice!, I intend to make this my very next project...:D :D :D