Crap what did I do....????

[TeamRebels]

The other day I desided to put in my reverse mod for my Savage.
A few hours later I was done things looked good.

Now for the last two days I have been tring to figure out what I did wrong.
As it will only drive in reverse now.
At first it was funny, now a few days later I am unsure what I did wrong.

Any help would be good, I am sure it is something simple that I have over looked or put in the wrong way, I just am not seeing it.

[TheLaxPlayer]

The first thing I would check is the linkage between the servo and the reverse module. If it is adjusted wrong, that may cause the problems you described. I do not have a Savage, so I don't have any other ideas.

[malibu4bbl]

here is a dumb question. did you try turning off the 3rd cahnnel??? i hope you did.

definitly check to make sure the servos is getting power and its not stuck in it. try to take it out of reverse manually.

fiddle with it!!!!

also ask i nthe monster truck section

[TeamRebels]

Oh I have fiddled with it, but yes turning off the 3rd channel I have done, then the truck just sits and does not move at all.

:(

[malibu4bbl]

hmmmmmm go to hpi section SAVAGE or Monster truck. im use less.

[RC action1]

Ive heard of some people saying that when they engage into reverse it doesnt go back to foward...Well your problem might be when you go into reverse the servo is stuck/ or not strong enough to engage it back to forward.. Check that out..

[crono man]

maybe the servo is set to "reverse" on your transmitter!?

[TeamRebels]

I have torn the thing down twice now, for the most part taking it about, then going back step by step again to redo it.

I check the transmitter, and it seems to be set fine, of course now I have done something as the poor thing is staying open (carp wise) now way to much, but that will be a fix AFTER I get this reverse thing done right....