boat stand plans?

[snoww4664]

does any body have any basic boat stand plans that will work for a nitro hammer or a simmilar boat, so i have an idea were to start. it would be apreciated alot. any idas or suggestions:confused: :confused:

[aamick1971]

try some pvc pipe,pvc glue ,elbows,tees,and tube.then use your your old stand for a giude. use 3/4" tubing or 1/2" this should not cost you more than ten dollars. allen

[haljmac]

here is a stand that is made of 1/2" pvc pipe. It should hold your boat. Needed:
4- 1/2" Tee's
8- 1/2" 90^
78" 1/2" pipe.
36" foam rubber (pipe insalation for 1/2" pipe)
pvc glue.
The 1/2" pipe will be cut as follows:
6@3"
4@2"
4@15"
This adds up to 76" the extra 2" is for the saw blade take out.

[haljmac]

...the file of the drawings are too big. I can E-Mail them if you like