Calling Mr. Ron Olson

[lovinnitro]

Hey Ron,
Can you tell me how I want to adjust the remote needle I picked up from you? How do I know when the needle seats and about how far out should I be to start with this K&BOB I,m doing?
I'm itchin to get it straight.
Thanks Man

[550racer]

hes back :D

[lovinnitro]

Hehehehe even with the Brady Family, New business and Holidays I can't stay away for too long...... Withdrawls you know! :D

[hydroracer]

hmmm, i haven't seen ron on any of the boards for some time now. hope all is well :(

ah,
just scrolled down and saw a response recently from ron. guess he's just been busy :cool:

[550racer]

his computer was acting up got it back the other day..

[Ron Olson]

I'm BAAAAAAAAAAAACK! The compuker had problems with the Internet Explorer so I couldn't surf, I could just send and recieve e-mails. It was down for almost 3 weeks and in the shop for 1 of them. $69.98 later and I got it back yesterday afternoon.
Anyhoo, back to the question at hand. Just adjust it as you normally would for any needle valve. Start at around 3-1/2 turns out then go from there.

[lovinnitro]

Glad to see your still wel. Thanks man. I was curious cause there is like a "arm" (third servo maybe?) that want to turn as well the needle valve is tight and just didn't want to damage it

[Ron Olson]

I was well until yesterday but still alive. I got that nasty flu from the kid and spent yesterday putting one end or the other in the toilet if you know what I mean.
I'm trying to remember which one that I sold you. I sold 2 that week plus some tuned pipes and other goodies. If it has the arm on it, that's for the 3rd channel fuel mixture adjustment.

[lovinnitro]

You sent me the K&B. The needle is real tight to turn so I can't really tell when its seating and I don't want to hurt it either.