pfc6477
01-26-2004, 02:16 AM
Any body have hsn and lsn settings on this engine,or factory settins for that matter?
rampbrian
01-26-2004, 06:07 AM
go to www.ofna.com
to the forums. there are a couple posts in the engine forum. and the picco engine forum that have diffrent things.
I got some settings from there. but some are in 1/2 turns and some are in full turns. hard to figure out. but I dont want to tell you the wrong settings. so just go look around.
also the settings are diffrent for the silver low speed needle / vs the black low speed needle.
rampbrian
01-26-2004, 06:09 AM
quick link
http://pub77.ezboard.com/fofnaracingnitrotalkbackfrm26.showMessage?topicID= 172.topic
pfc6477
01-27-2004, 01:53 AM
Originally posted by rampbrian
quick link
http://pub77.ezboard.com/fofnaracingnitrotalkbackfrm26.showMessage?topicID= 172.topic
rampbrain dude you rock.Thanks for that great link:D
rampbrian
01-28-2004, 02:21 PM
hey, when your attempting to start your engine for the breakin process, I highly reccomend wearing some sort of gloves.
the pull start handle is kinda small, so its easy for it to cause blisters, and the cooling fins are SHARP!!!!!!!! a couple good hydro locks from being flooded, and that cooling head will give ya some nice cutts on your fingers.
its no good when your bleeding on your truck trying to do break in. hehehe:D
just tellin ya from personal exp.
btw, once the engine fires, it runs great on the breakin setting ( factory pre set ) and it spews out lotts of raw fuel and oil, verry nice once it starts, getting it to start is another thing.,:rolleyes: