corey c
05-19-2001, 09:07 PM
Need some help people! First let me tell you about what I have then I'll tell you the problem. The equipment I have in my plane [ultra-light looking thing at 1.5oz ready to fly]is an mx-6800 rx [maxx products], two mx-30 servos [maxx products],e-chargers motor [same as n-20 or kp-00], servo amp board for motor controller [waiting for my pixi-p], 3-cell 50mah nicad pack.With this set-up everything works fine. Now the problem! I tryied to use a cr2 lithium cell but nothing works very good, servos and motor barely do anything. [also tryied a 3.6v lithium]. My rx works down to 3v [advertised] but with my 50mha pack everything works good even untill the pack does not have enough juice to turn the motor. I'm thinking that these cr2 cells can't handle the higher current drain. Is there ant way I can get a cr2 cell to work ? also could this be from the servo amp board I am using? Any thoughts?