motor cooling

[BoatDoc]

i'm trying to set up a cooling line for the endbell on my motor. can someone post a few pics of how it's done?? i've got a coil around the can, but the endbell is getting WAY too hot. thanx.

[SixVi6-Camaro]

http://home.comcast.net/~sixvi6-camaro/Villain_02.jpg

Here is how its done on a closed endbell motor. This is on my Traxxas Villain EX. you soder brass tubes to the actual soder tabs of the motor then conect water lines to the brass tube. Its lind of a pain to get the wire and the brush coolers on there both at the same time but the resulta are great. I run pack after pack with no cooldown and the motrs only get to around 100degF.

[BoatDoc]

my motor is an open end bell, but that helps a little. i may be able to come up with an idea or three from that. thanks. anyone got some pics for an open end bell??? i have a few ideas, and that pic gave me some more, but i'd like to see some other examples.

[SixVi6-Camaro]

http://www.fastelectrics.com/brushcoolers.htm

This link has a how to and pics of open endbell brush coolers.

[BoatDoc]

that looks like an awesome idea, thanks again.

[BoatDoc]

i got the water cooling set up and ready to go. it'll get tested this weekend. i went with something like in the second link. thanks for the help!

[SixVi6-Camaro]

very cool.. glad I could help. :)

[porschefan911]

i looked at this thread too late but i did like its done one fast electrics and it works great...my setup was so harsh that my leads came off and when i installed the brush cooling it worked like a charm...glad i could help ;)