View Full Version : Txt1 Driveshafts
DMAXX999
12-12-2004, 01:05 AM
Does anybody know how to adapt the tmaxx driveshafts to the txt-1? :confused:
egdinger
12-12-2004, 01:27 AM
I'm not sure but I think all you have to do is take off the old shafts and put the t-maxx shafts on it.
Does anybody know how to adapt the tmaxx driveshafts to the txt-1? :confused: go to www.rc4wd.com but I think thay cost a lot.
Jeckler
12-12-2004, 03:21 PM
Jeez. No, don't goto RC4WD. Got to your local hobby shop and get a set of Revo shafts instead, along with a set of HPI short setscrew pins. Goto R C M T or rccrawler and see how to install them. They are a bolt on, with only a minor clearancing of the tranny case. If you want to keep the stock wheelbase, you'll need to shorten the new shafts as well. Or, another simple mod that costs absolutely nothing will lengthen the truck 2.5 inches, and you can keep the nice boots on the Revo shafts.
Jeez. No, don't goto RC4WD. Got to your local hobby shop and get a set of Revo shafts instead, along with a set of HPI short setscrew pins. Goto R C M T or rccrawler and see how to install them. They are a bolt on, with only a minor clearancing of the tranny case. If you want to keep the stock wheelbase, you'll need to shorten the new shafts as well. Or, another simple mod that costs absolutely nothing will lengthen the truck 2.5 inches, and you can keep the nice boots on the Revo shafts. Cheaper is better!!! I do not buy stuff from rc4wd ether! But it was the only place I knowed to send him/her.