Where can I get a longer rear driveshaft for my T-maxx .21 conversion?

[dlx3200]

I got a .21 conversion chassis for my T-maxx. Now I need a few other parts like a longer rear driveshaft and the piece that for your throttle linkage. It's for the slide carb. I don't know what it's called. Your rod runs from the servo to this "T" looking piece then from there to your slide carb. It works the carb. Thanks for any info.

[zakerid]

depends on the conversion. You can get them from Dynamite, XTM, New Era...

[dlx3200]

It's a Racers Edge chassis.

[RespirologyRC]

Check out the thread on .25 Storm Sut, I have a couple of pics the engine and the way I have my slide carb configured with my .21 T-Maxx conversion. I took a wire coat hanger and dremeled the ends to fit the linkages for the slide carb and other stuff. Let me know if you have any questions. There are a couple of other ways that you can do this.

[zakerid]

sales@racers-edge.com
You can email racers edge. maybe they will hook you up with the parts you need.

[dlx3200]

thanks guys!!! :D

[dlx3200]

RespiroloqyRc can you post the pic's on here. I don't want to be a pain in the ***. I did a search and can't find .25 Storm Sut. What forum was it under?

[noonizzlecfl]

yo, no joke, just get the stock long half-shaft, go to towerhobbies.com and search for traxxas long half shafts. basically they are the cvd's to the wheels

[Natedog]

http://www.rcalloys.com/ that's where I got my custom length Savage center driveshaft. Strong stuff!

[RespirologyRC]

i'll some in a couple of hours.

[RespirologyRC]

Here are the pics (3).

[RespirologyRC]

In the pic with the ruler, you can see that the marker shows 7" . The regular length of the one that would normally come with the TRX 2.5 is about 4.5" . Like I stated above I took a hanger and dremeled it until it was smooth and actuated without any hickups.

[RespirologyRC]

Ignore the holes in the photo above. I have my chassis setup for a 2 engine capability.

You'll also notice that my throttle servo is not in place. This is because I cut the wire accidentally and now have to put it back together.

[Natedog]

yo, no joke, just get the stock long half-shaft, go to towerhobbies.com and search for traxxas long half shafts. basically they are the cvd's to the wheels

Ah, yes if you're stil using the stock Traxxas style slider driveshafts. I assumed that ya went to drivecups and regular style dogbones since ya got the bigger engine in there. :D

[dlx3200]

Thanks for the pic's. It helped out a great deal. Again THANKS everyone!!