engine for my 1/4 scale P-51

[mediamagnate]

I am in the process of gathering parts for a large scale P-51 (plans by Dan Santich). I am ready to leap into large scale... need help though. I can't seem to find a good Internet source for engines in the 2.5 - 7.4 cu in range. Any suggestions or links any one would recommend? :confused:

[GrahamS]

I am in the process of gathering parts for a large scale P-51 (plans by Dan Santich). I am ready to leap into large scale... need help though. I can't seem to find a good Internet source for engines in the 2.5 - 7.4 cu in range. Any suggestions or links any one would recommend? :confused:I have the same plans...recieved them today, make shure fuselage is to proper scale...mine was 20 inches too short!!! Anyway check out for posts on motors,setup....ect,ect,ect. I'm modifying my plans for better scale appearance and function. Let me know how things go!

Graham

[mediamagnate]

sure will graham, I am trying to get my Garage... aka work shop in a more tidy situation and then hope to start... heck a couple more months wont hurt...I've had the plans for some time now.

[merlin7111]

I have found the perfect site....Engines are not cheap but they have real working headers and everything... check outhttp://www.clarkindustries.on.ca/.

They even have other stuff for the 1/4 scale.

[dgoldie]

I am in the process of gathering parts for a large scale P-51 (plans by Dan Santich). I am ready to leap into large scale... need help though. I can't seem to find a good Internet source for engines in the 2.5 - 7.4 cu in range. Any suggestions or links any one would recommend? :confused:

you can also go to rcwarbirds.com and post this question to the folks there. A good site to use for reference if you are getting into large scale war birds.
Dave

[Pro Flyer]

Hi mediamagnate
I have got a Model Design P-51 D Mustang 1/4 scale 101" wing span I am going to run a Zenoah G62 with a Mick Reeves reduction drive. :)
Here is a pic of the motor and plane.

Damo :cool:

[Pro Flyer]

:)
Damo

[mjb41847]

I am in the process of gathering parts for a large scale P-51 (plans by Dan Santich). I am ready to leap into large scale... need help though. I can't seem to find a good Internet source for engines in the 2.5 - 7.4 cu in range. Any suggestions or links any one would recommend? :confused:
I have a P51D Giant for sale , not complet I have engine (US Engines 41cc 2.5cu in Gasoline Recommended Prop: 18x12,20x8 It has never been started NEW in Box. If you know of anyone wanting the whole thing Landing Gear,parts, etc. Contact me at mjb41847@sbcglobal.net or Call me at 314-773-2172 morning hours.