g-260 stalling out

[badd_maxx.25]

hi i have a zen g-260 it runs great for about 10-15 min then just dies, restart it and it run fine for another 10-15min and does the same its in a 57" deeep vee with whobbies wet pipe

[scorpien boats]

I know it sounds like a dumb question but are you sure you have enough gas in the tank? sometimes if you are kinda low, the gas moves around then air bubbles get in the line and then it dies, thats what was happening to mine.

[badd_maxx.25]

the first time it did it i thought that mite be the cause so i filled it up and she did it again.

[Chris LaPanse]

Needle settings? Also, what level is the pipe? I've seen one where it had the pipe mounted too low, and if it wasn't adjusted perfectly, every time it would stop, water would hit the end of the pipe and cause it to stall.

[badd_maxx.25]

stock needle settind , the pipe is water cooled , mounted just above the water line

[BMAD01]

Do you have a tank vent?? I sure hope so, cause what yer describing sounds like ya do'nt. Without a proper tank vent, the tank will create a vacume and the carb wo'nt be able to draw fuel, ending in a stalled engine. :eek: Brian ;)

[badd_maxx.25]

it has a vent

[aquajetruner]

Can you post some pictures of your setup?

[mustangman05]

I had a homelite do that to me my plug was fouled also me carb's fuel pump screen was dirty..