PDA

View Full Version : aeromarine pro cat 50"

mike R
06-09-2005, 04:01 PM
looking at the aeromarine pro cat 50", been checking out the boards for some time now and have not seen anything about this cat. can anybody tell me anything about this boat. (good,bad) im not raceing just messing around on the lake. going to use a g26 for power. thanks for any info.
mike
Chris LaPanse
06-09-2005, 06:25 PM
Well, I don't have any specific experience with this boat, but if it's from AM, it should be good. A G26 should move it along nicely in the 40's.
scorpien boats
06-09-2005, 07:05 PM
HI and welcome.

I too have had no experience with that boat but I have never seen a bad aeromarine boat. (I have an aeromarine boat and I like it)
g260 will be great.
Ron Olson
06-11-2005, 01:00 AM
If I were going for an Aeromarine Cat, I'd go with the Avenger or Cyclone. They're shorter but I like the looks of them better and 44" is a lot easier to haul around than 50". I have a hard enough time getting a 40" hull up and down my basement stairs but my stairway is "L" shaped.
mike R
06-11-2005, 09:53 PM
If I were going for an Aeromarine Cat, I'd go with the Avenger or Cyclone. They're shorter but I like the looks of them better and 44" is a lot easier to haul around than 50". I have a hard enough time getting a 40" hull up and down my basement stairs but my stairway is "L" shaped.


thanks for the info, i was thinking of the avenger, but i still think im going for the pro cat so far, as long as i dont hear anything bad about it. as for lugging it around thats not a problem. ( my wife is pretty strong). thanks again.
mike
Doubledog
06-12-2005, 02:19 AM
as for lugging it around thats not a problem. ( my wife is pretty strong).
mike


I like this guy already :D
dbm0011
06-14-2005, 06:43 AM
Hey Mike. I went to Aeromarine met with Troy and Remy jr. I had custom built (they did a couple of extra mods for me on the hull.)
Avenger Pro Cat 44" (removed 1/2" of the running boards, Carbon Fiber Sponsons)
Zenoah G260PUM - Modified - Ported Polished blueprinted - Butch The Boat Man
6717/3 prop - Pre balanced sharpened - The prop Works

This was a one stop shop for me. Troy and Remy took care of everything. I left 6 wks later with a RTR CAt.
I say 6 wks, I went up to DE, ordered the boat, waited 3 wks for them to even start working on it, then 3 wks later, took another trip up to get it. :D