PDA

View Full Version : removing pulley

JoshsTL01
07-10-2005, 09:34 PM
how do i remove this silver piece, that holds the 20/15 groove pulley on the 4-tec, from the pulley shaft? i dont want to break it, but i cant think of any way to take it off.
http://x2.putfile.com/7/19020342049.jpg
LandSharkGT
07-10-2005, 09:41 PM
Just stick a small screwdriver in the opening of the C-Clip and twist so the clip comes off the shaft smoothly. To replace it just use a pair of pliers to slide it back into it's groove.
JoshsTL01
07-12-2005, 07:59 PM
got it off. thanks landsharkgt for the tip.
LandSharkGT
07-12-2005, 09:22 PM
No problemo!
Duster_360
07-13-2005, 11:25 AM
Be warned, these clips have a well deserved reputation for flying off and disappearing! Keep a finger on it while you pop it off and put it back on or get some spares in case. I've had them go all the way across a room before (stupid clip, took nearly an hour to find it - before I bought spares!).

They mostly fly off when you're trying to get them back on. I use needle nose pliers to get them put back on.
JoshsTL01
07-13-2005, 11:28 AM
i have 2 extras just in case, but i didnt have a problem with these.
Duster_360
07-13-2005, 11:34 AM
Yeah, thats a pretty big one. The smaller e clips that go on hinge pins are usually the fun ones!

Is that a 2.5?
JoshsTL01
07-13-2005, 05:16 PM
Yeah, thats a pretty big one. The smaller e clips that go on hinge pins are usually the fun ones!

Is that a 2.5?
yea it is. nitro 4-tec.