Brushless installation questions.

[bigair78]

I just got my mgm 8012 in today and I am getting ready to install it and my feiago 8s into my rustler. I have a couple of install questions:

1.) Can I bend the leads on the motor so they face the direction of the controller?

2.) If it doesn't reach can I put some short leads in between the leads from the controller and the motor?

3.) What else should I do pryor to turning it on.

4.) How is programing on this controller? Easy or Hard to do?

[chilledoutuk]

in quick reply you can bend the cables coming out of feiago motors and you can extend the motor cables if needed but try to keep them as short as possible.

I dont have an mgm controller there not the easiest to program but im sure if you have any problems the other mgm users on here will give you a few pointers.

good luck

[tcolesen]

Programmin the MGM controllers might make you frustrated at first, but once you get it, you get it. Also, when I had my controller, I found that it didn't beep/flash as many times as the instructions said it would. That was part of my frustration. Just remember, patience is a virtue!

[bigair78]

Had very little trouble programming the system. It runs well though I thought it would be a little faster.