Motor Connectors for Novak Super Sport Plus

[russellr2k4]

One of the reason I got a Novak Super Sport Plus is because it can run brushless and brush motors. The problem is that each time I have to change from brush and brushless, I have to resolder the motors. I don't solder great and it always seems to take me longer than most. I looking for connectors that I can use so I don't have to resolder. For my old ESC (Novak Dually), I had Dean's connectors but Novak Super Sport Plus has three wires to the motor. Thanks in advance...

[XXX-T for me]

You could use power poles here (http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD175&P=7) or check with your LHS in the airplane department since most planes use brushless motors.

[nicholcgn]

I just used 2 sets of deans connectors for My system. Works great and I already had them. I do not have the SSplus but I am sure you could do the same thing. Just make the harness towards your brushed motor in the correct config.

[bholio]

I would use powerpoles. The connectors themselves can snap together making a large single plug so its easier to attach and less likely to attach the wrong wires together.

[CharlieS]

I've seen poeple cut a Deans in half to make the 3rd wire connectio, that's what we'd recommend as Deans are by far the best connector in my own opinion.

There are some airplane connectors on Tower that are 3 pole as well. They seem very nice, but are not "reverse" proof if you know what I mean.\

Thanks