TimisTim
08-01-2005, 10:04 PM
Alright I have read the manual and need help! Can someone break down the programming of the MGM 12012 for me. Please!
I will be very greatful.
tcolesen
08-01-2005, 11:51 PM
I don't have a manual in front of me, but I can try to help. One thing to keep in mind is that the controller doesn't beep/flash as many times as the instructions say, so it can be a little frustrating.
1. Go into programming mode by holding full throttle (or reverse, whichever it is).
2. Push the trigger however many times you need to to get the desired setting for the first parameter. After each pull, wait for it to beep twice (or whatever it does) before you push the trigger forward again. Pull full throttle once you input the number of pushes necessary to select the desired option. The controller will beep three times.
3. It is now onto the next parameter. Do the same thing as 2.
4. Repeat until you have programmed all of the parameters. Once through all of the parameters, the controller will pretend like there is still another parameter, even though there is not.
5. Turn off the controller. Turn it back on and use it. You can also turn the controller off before you finish the programming if you don't want to set any more parameters.
Make sure that you know which parameter you are on, as you can set things wrong if you are inputting for parameter 3 when you are actually on 2 (just make sure you set your eyes to the next parameter after each full throttle pull).
I hope I covered everything, as I don't have any instructions to look at. This is all strictly from my memory of programming the controller a few months ago (once you get the hang of it, you will remember it as I have).
TimisTim
08-02-2005, 12:42 AM
Sounds good. Thanks alot. I will try it out in a minute. Just got my new (used) TC3. This controller is not a very good fit for any car! It will be in my MT2 conversion soon as my UF75 gets back from Germany.