.26 in T-Maxx

[f350maxx]

I found a Ofna .26 small Block on Ofna's website, what all would I have to get and do to put it into my T-Maxx? Thanks for any advice,
f350maxx

[Peterbilt]

I found a Ofna .26 small Block on Ofna's website, what all would I have to get and do to put it into my T-Maxx? Thanks for any advice,
f350maxx

If you are talking about the engine I think you are, then it will drop in with no modifications. It was made specifically to be a direct bolt in. However, your stock driveline might not like it too much.

[Duster_360]

.... However, your stock driveline might not like it too much.


Soon as breakin is over and you start to giving it throttle, you'll be having probs blowing the rear diff and twisting your plastic driveshafts. Soon as you get past that with something stronger, then the front diff will go and whatever drive shafts you didn't replace. Then the slipper and the trans will be your weak point in the drive train and you'll have probs with those. Oh yeah, the stock clutch won't handle that power either, you'll be going thru those pretty rapidly too. Get spares....Been there, done that, lol.

Its fun breaking parts with power the 1st few times, after that, it gets old, especially watching others run while yours is broke. Good luck!

[f350maxx]

Thanks guys, I probably just put a new exhaust and a new cooling head, I don't feal like replacing parts all the time.

[Racing t]

but then you can get robison racing steel gears on your transmition, they will handle de power very well.