truck wont stay running after i take the ez start off

[jedwards1212]

The truck wont stay running after i take off the ez start. I starts fine and revs good as long as i hold the button down. i put in a brand new glo plug and it wet the plug when i put the needles to factory defaults. Man i need to get my Revo back in order. Do you have to shake the gas before you use it. How much supply line do i use i replace the lines. help me get this truck moving again.

[apollo]

sounds like your running really rich, factory specs are set rich for break in, lean out ur hsn and try it again

[Joe Brinduse]

The truck wont stay running after i take off the ez start. I starts fine and revs good as long as i hold the button down. i put in a brand new glo plug and it wet the plug when i put the needles to factory defaults. Man i need to get my Revo back in order. Do you have to shake the gas before you use it. How much supply line do i use i replace the lines. help me get this truck moving again.
take the truck to your lhs they should be able to help you get it adj in .

[zakerid]

check you glow plug and make sure your battery is fully charged...

[Dad-to-a-Marine]

I agree with Apollo, you're running way to rich. Reset your carb to the factory breakin then lean it out 1/2 turn and give it a try. Remember not to run it to lean, heat kills.

[savagemachine]

Right lets go back to basics put all settings back to factory change glow plug even though it sems ok truck might not like running on it as i have had the same problem with my savage it will only rum on OS NO8 MC59 and will not run on anything else this is both engines i am talking about here not just 1.

Start truck up and see what happens by running on different brand of glow plug and factory settings

Keep us informed on how things go

Savagemachine