studysession
04-03-2006, 03:58 PM
I have an email from BK-Electronics saying that the programming cable they offer can be used for setting somethings on the Warrior 9918 controller. So I went ahead an ordered it.
I have a problem. I loaded the settings from my controller to the program. Did not make any changes but told it to write the same settings back to the 9918 controller to make sure it would actually work.
Then powered everything up with same batteries I used yesterday and transmiiter. The steering servo works when I cont the battery to the ESC but I can not drive the motor now.
I try replrogramming the controller for the the transmitter I have and still did not help. I get the first beep that says it registers neutrel but no beep registering the forward motion of the stick on the transmitter.
Any ideas????? Thanks.... :confused: :eek:
I have a problem. I loaded the settings from my controller to the program. Did not make any changes but told it to write the same settings back to the 9918 controller to make sure it would actually work.
Then powered everything up with same batteries I used yesterday and transmiiter. The steering servo works when I cont the battery to the ESC but I can not drive the motor now.
I try replrogramming the controller for the the transmitter I have and still did not help. I get the first beep that says it registers neutrel but no beep registering the forward motion of the stick on the transmitter.
Any ideas????? Thanks.... :confused: :eek: