Schulze U-Force and Fiegao 380 6S Still going strong..

[Danielson]

Hi All It's been sometime since I have been here and the reason is for the last 6 months everthing whith my bl system is going great and still is..
At a recent event I went to my bl system was not legal so I bolted in a new 9 double motor and was dissapointed with its lack of power!! I ran the 9 turn with the u-force and it worked fine but was not even close to my bl setup.
The only minor problem I have had with the fiegao is in the event of a collision :mad: , sometimes the motor can moves slightly on the motor mount and causes an overly tight gear mesh.. But apart from that maintence free for 6 months or more. I am a happy bl user :) , thanks to all for your help and advice in my earlier days..
Regards Dan :p

[TimisTim]

Good to hear. As far as the motor movement problem just throw a washer under the bolt to give greater surface area. It will increase the holding power of the screw alot. I love my UF75 for 1/10 racing. Heck I used to have three! Two are sold to fund other projects controllers.

[tcolesen]

That's too bad you have to revert back to a 9t brushed motor! I know that I will not go back to brushed, even for racing! (which I don't do anyways)

Don't you think it's about time to clean/replace those bearings? :)

[Muck]

I'll have to agree. I have had a 380c motor since they first came out. It is a great little motor. I though it might have less torque than the 540 8t I was using before, but it is right up there. It is also much lighter wieght which helps it fly through the air better. Pair it up with a U-Force (my favorite) or Genisis Pro and you have a top of the line system.