schulze throttle problem

[mrkinigit]

I'm trying to program a schulze 18.97kw, ubec,paired with a feigao 540-8s using a hitec agresser 3ch fm.
My problem is that even though I've got the switches set right(i think), its giving constant throttle. The motor doesnt stop unless I have the trigger in full reverse. My switch settings are
1- on
2- off
3- on
4- off
5- off
6- off

[starluckrc]

The first two appear right for land use. 5 and 6 need to be changed as that is the hardest timing for higher pole motors. The Feigao is a 2-pole motor run best at the softest or next to softest timing setting.

[Maxx42]

I have that controller for my emaxx and have used it with a 9L and 7XL. I usually have switches 1, 2 and 3 turned on and 4, 5 and 6 turned off. That setup has always worked well for me.

[kufman]

4=off
5=on

Will be the best setup for feigao motors. better for the controller since it will cogg less on startup.

[Maxx42]

How did it go? If you go with the manual that comes with the controller, Kufman's response is the correct one for feigao motors as long as you keep your other switches as you had them.

[mrkinigit]

Yeah, I did try kufman's suggestion.
Same effect as before. The only way it was drivable was to wrap a rubber band around the trigger so that it would hold in the full brake posistion. Only problem to this was that I had no brakes or reverse.

[kufman]

Did you try reversing the throttle channel?

[Craps]

Sounds like the radio needs to be bound to the ESC again.

[mrkinigit]

yeah, the programing isnt sticking.
Turn it on and it doesnt fully arm. Full gas and I get 2 beeps, full reverse 2 beeps and then it automaticly gives it gas.