Spektrum DX6 Help Required

[Draxyl]

Hi,
I have just bought a Spektrum DX6 and need some help setting it up for dual aileron servo operation.
I have the left aileron in Channel 2, right aileron in Channel 6.
I have setup Prog Mix A... Channel 2 -> Channel 6.
The ailerons work properly, but the aileron trim only affects the left aileron (master channel) not the slave channel (right aileron).
I have another JR transmitter, and the trim always worked automatically.
Does anyone know what else I need to do?
What about the switch positions for these channels?
The manual is not too clear on this, and the local hobby shop can't figure it out either.
Thanks!

[aeajr]

I dont have your radio but you should be using the flapperon mix. Is that what you are using?

[kingsnake93]

you have the left servo wing in channel 6 and you have the right wing servo in channel 2. When you are about to turn on the TX you hold the red buttuns up and while still holding the red buttuns up turn on the TX. Then you should see somhting that says "typ AC" press "scroll" till you see somthing that says "mix WNG OF" then press "increase" button once till you see "mix FPR ON" that means the duel servo thingy is on. You adjust the right aileron by using the flap trim. Hope this helps.