View Full Version : Servo Saver Question...
JaWs66
03-14-2007, 11:11 PM
Who makes the best servo saver? Im gonna use them on a Clodbuster with Thunder Tech bumpers front and rear. I was looking at the OFNA servo savers with the CNC tops, any comments on these or others I should be looking at? Thanks...
ericem
03-14-2007, 11:31 PM
Check out the Monster GT servo savers, they are VERY strong and keep the wheels straight!
OR you can try LST savers, and slip on a couple more springs, but the MGT is equal to that, and both have the same durability.
shadowghost1
03-15-2007, 09:32 AM
Try these......
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFNE8&P=7//url
or
http://www2.towerhobbies.com/cgi-bin/wti0001p?&W=000139916&I=LXS361&P=K://url
I have found these to be the best for crawling.
BrandonWilcox
03-15-2007, 03:35 PM
ive also had good luck with kimbrough:
http://www2.towerhobbies.com/cgi-bin/wti0001p?&W=000139916&I=LXS361&P=K://url
brandon
JaWs66
03-15-2007, 10:31 PM
The ones I just blew out were the redish Kimbrough savers... not sure if Ill try them again! Any others out there???
ericem
03-15-2007, 10:48 PM
Check out the Monster GT servo savers, they are VERY strong and keep the wheels straight!
OR you can try LST savers, and slip on a couple more springs, but the MGT is equal to that, and both have the same durability.
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFUL4&P=7
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFUL5&P=7
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXFUL0&P=7