2.2 droop VS

[tq_racing]

First up I gotta give a big thanks to Double J for the Vertical Smile I could not be happier with it.

Specs:
TLT Axles locked with 3rd gear method, full bearings.
Pede Tranny (cut way down for weight and fit)
Moabs (foams cut in star pattern and narrowed, pennys added for weight 12 in back 24 in front for each tire)
Unknown rims narrowed to have the hex flush wih the back bead overall width of 1.45"
Custom made servo plate
TQ3 Radio gear
Moped ESC

On to the Pics:

http://i172.photobucket.com/albums/w4/caddexpress/IMG_0452.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0456.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0469.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0468.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0467.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0466.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0465.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0464.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0463.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0461.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0460.jpg
http://i172.photobucket.com/albums/w4/caddexpress/IMG_0459.jpg


Any and all input is welcome good or bad, I have not had a change to get it out and dest it, as I am needing a 2/3A pack, the SC's that I had are just two big.


Thanks Everyone.
TQ

[nthstr]

Looks good. I do have a question for you. You mentioned adding pennies for weight, where did you put them?

[tq_racing]

Put 12 around the "rim" with duct tape to hold them in place. then in the front placed 12 around the rim and the inside tire with duct tape.

My father gave me the idea of adding sand instead of air soft bb's.

May give that a try a little later.

[savage100]

Hey! Where's the flex shot? Looks pretty cool.

[tq_racing]

flex shots that are not on the rocks are over rated. Testing tomorrow at the local comp will have pictures and hopfully a short vid of it.