seagull369
03-12-2008, 02:35 PM
Hi, folks. Just signed up on the site :)
Was wondering if anyone out there knew what the measurements given for a typical bearing in question refer to. For example, my Team Losi xxx-nt manual lists a flanged bearing (which I need a replacement for) with measurements 1/4" X 3/8". I'm assuming the first number indicates the inside diameter(ID), while the second is the OD, but am not entirely sure.
A flanged bearing I saw on eBay goes a step further and lists its dimensions as 1/4" X 3/8" X 1/8". I'm assuming the last dimension there refers to the bearings depth (or cross sectional width), but again that's just a guess.
I tried searching this site and the net on this but couldn't find any leads, so any help would be appreciated!
Was wondering if anyone out there knew what the measurements given for a typical bearing in question refer to. For example, my Team Losi xxx-nt manual lists a flanged bearing (which I need a replacement for) with measurements 1/4" X 3/8". I'm assuming the first number indicates the inside diameter(ID), while the second is the OD, but am not entirely sure.
A flanged bearing I saw on eBay goes a step further and lists its dimensions as 1/4" X 3/8" X 1/8". I'm assuming the last dimension there refers to the bearings depth (or cross sectional width), but again that's just a guess.
I tried searching this site and the net on this but couldn't find any leads, so any help would be appreciated!