jasonhill
06-06-2008, 10:26 AM
Like the title says, I am new to this. My question is, is it possible to sync two servos to do the same thing like steering? And where is the best place to get all the electrical componets needed for 1/4 scale? Is there one "better" than another? Any help would be great.
Thanks,
Jason
rccardude04
06-06-2008, 05:18 PM
This depends on the precision you need...
If you just need them to receive the same signal, a device called a "Y-Harness" will do the trick. It's just a wiring harness that changes 1 servo output into 2 so that 2 servos will do the same thing.
However, if you need adjustability, you might look into a product from JR called a MatchBox. This will allow you to set the amount of travel each servo has independent of one-another. It's typically an airplane thing, so you might have to look for it in the aircraft section of the hobby shop.
As for the "best place" for 1/4 scale components, you don't need anything special. Local Hobby Shop can help you get set up.
-Eric
jasonhill
06-07-2008, 02:48 PM
Thank you for the info. This helps me out a lot.:D
jason