Help with Futaba 3pm 2.4 setup

[cadeezy1]

I installed a 603FF rx in my TA05 today to pair up with my Futaba 3pm 2.4 fasst tx. initially i had to set the trim so that there would be a neutral setting because when i turned on the car it would be at full throttle. i fixed that but now when i push the trigger forward while the car is on, it goes into throttle again instead of brake. can anyone please help, this is frustrating.

[rccardude04]

Most speed controls require that the throttle servo channel is reversed on Futaba radios.

You also NEED to zero trims and subtrims, and re-calibrate your speed control to the radio.

-Eric

[cadeezy1]

will try, thanks!