GWS pinion gears puller

[GWS4CEO]

Some time about end of last yea, Ezoner had asked GWS to make a gears puller. Unfortunately, since GWS was flood by a Taifon strick. Too busy at them to recover production site.

Finally, there will have 2 differnt sizes of gears pullers to come.

Standrad: for using to remove gears from 3 types gears at shaft size 1.0mm; 1.5mm; 2.0mm.

Heavy duty: 2.0mm, 2.3mm, 3.17mm

The CAD design of this gears pullers. Under prepering the parts and test production. Wish this will be help?


__________________
Houng-wen Lin / CEO of GWS

Grand Wing Servo Tech (Taiwan)
http://www.gws.com.tw
http://www.grandwing.com.tw

[Mikerjf]

Include one each in my other order.

Mike

[GWS4CEO]

The big one in USA about $12, samll one for $10.:) Every Eflyers should get both of this tool.

[GWS4CEO]

Wish every E flyer will have both size. Standard for $10, Large for $12. Is this a deal?;)

[Basketcase]

Yes, a very good deal. :) Will buy both as soon as possible.

Thank you Mr. Lin.

BC

[GWS4CEO]

GWS gear pullers information
http://www.gws.com.tw/english/product/other/gp.htm

[shaky mark]

Greetings Mr. Lin,

Once one has the gear pulled off one motor, how does one correctly(without damage) put it on another GWS motor?

Thanks for your products that allow us to dream and affordably expand our participation in this great hobby.

Mark

[wwagner]

shaky mark,

Try using a C-clamp as a pinion press . . . hint . . . drill a hole in the center of the flat part of the clamp, this will be for shaft relief
hope this helps


wayne