help on maximum st pro

[phatcat]

i have a problem with my max st pro. the pressure fit hexes keep coming loose. do you guys know of any cvd's that will fit my car? i was thinking about cvd's because they have a cross pin that goes through the wheel hex which should stop the problem. i also need help on getting the pressure fit hexes off my car. thank you.

[Mason Copeland]

Put a drop of thread lock on the threads before you thread the bolt on, then they should hold very well.

[jives]

If you have the Pro version then it came with the only CVAs I know about (Duratrax calls them Universals).

Keeping them on just tighten the nut really tight, if the nut is coming loose get some different ones or try a little thread lock.

Taking them off undo the top arm on the C hub and lower it down then tap the axle back thru.

[pudder]

Go to your LHS and ask if they have any axles that have the pin hole. They may have some. If not, get the DuraTrax Universals, or maybe measure the length of from the gearbox to the end of the axle, and see if any MIP CVD's would fit.

-mike