Where do you mount your onboard temp gauge.

[Got Speed]

Where do you mount your onboard temp gauge on your T-Maxx?

[RC Jack]

Using 3M double sided tape, mount it where you can see it the best from an angle that doesn't require you to be a contortionist. The top of the battery/Rx box is a good place.

[Got Speed]

I was going to try to put it on the batt box or reciever box but the wire won't reach?!

[Got Speed]

Has anyone mounted it on the back side of the fuel tank? I wonder if the shock tower broke would it smash the temp gauge?

[RC Jack]

The backside of the fuel tank? Wouldn't that be somewhat inaccessable? How 'bout makin' a small aluminum plate and permantly mount it somewhere, preferably lower than the top of the engine, (I'm not familiar with the T-Maxx, btw).

[Got Speed]

I thought about that but the chassis isn't just a flat plate. There is nowhere the wire will reach that dosn't go over the spur gear.
The back of the fuel tank is all I could think of. But I don't want it getting crushed if the shock tower breaks.

[smokinoutlaw]

I ran my wire through the rear shock tower and taped it to the back side of the tower, i also put a tip tie around it not tight, but enough to hold it from comming off. With it mounted here you can see what temp your running with out removing the body.


:cool:

[Got Speed]

How did you attach the lexan shield?